16
· The dispenser should be placed in indoor where is cool and well-ventilated. Keep away
from direct sunlight, heating elements, or anywhere is hot.
· The dispenser shall not be placed in place that may have inammable gas leakage.
· To avoid electric shock, do not touch the power plug with wet hands.
· To avoid damage, do not disassemble, remodel the machine by yourself, or put any heavy
objects on the machine.
· If the dispenser will not be used for a long time, please make sure it is disconnected from
the power supply, and empty the water tank.
· The inlet water temperature should be 5℃-38℃. If the temperature is higher than 38℃，the
lter cartridge will be damaged and unable to work. If the temperature is lower than 5℃, the
dispenser might be frozen and the elements of the dispenser will be damaged.
· The dispenser can only be installed and used indoors, and with power supply of reliable
grounding.
· During the rst time use or when the dispenser has not been used for a long time, please
clean it repeatedly until it is cleaned completely; it can only be used after thorough cleaning.
· Always use certied elements and accessories for the repairment and maintenance of the
dispenser.
· Organic solvent such as gasoline etc. shall not be used for wiping the housing of the
dispenser. If cleaning is required, please gently wipe the surface of the product with wet
cloth after it is disconnected from power supply.
· If there is any abnormality, unplug the product from power supply immediately, and do not
leave the defective dispenser in working mode.
· With upgrade of the product, certain words or pictures on the manual may be dierent from
the actual product, and the actual product shall govern in this case.
· The dispenser is suggested to be used in areas whose altitude are no higher than 1,200 m.
· If the user intends to extract ambient water or water of 45℃ immediately after extracting hot
water, some hot water may come out at the beginning, if so please watch out to avoid being
burnt by the hot water.
· If the power cord appears to be damaged, please stop using the product. To avoid risks of
danger, the power cord must be replaced by the manufacturer.
· Do not disassemble or repair the dispenser by yourself, or hand it over to customer services
not authorized to repair, as improper repairing may cause risks of danger.
8 Routine maintenance
（1）If the product is not used for over two days, it is suggested to change water in the raw
water tank and then empty the inner water tank for the ltered water (Long press “ ”+
(85℃ button) “ ” (300ml button) for 3 seconds.) Repeat the process twice.
（2）If the product will not be used for around or more than one week, please empty the water
in it and disconnect the dispenser from power supply. Seal the lter cartridge and store it
in refrigerator (2-5°C, do not put it in the freezer). When use it again, please follow the
procedures above-mentioned to clean both water tanks.
To Next Page
Loading...
Need help?
General
