h. Check if the system is installed properly, and
turn on the three-way ball valve.
9
V. Using the system
1. Before the first-time use
a. Connect the system with power. You will hear a beep, and all indicators will light
up for 3 seconds. The system flush will be automatically on. Wipe all the joints
and connections with tissue to check if there is leakage. If the tissue stays dry,
it means the system is installed properly. If there is no further operation after the
auto-ush, the system will turn into standby mode, and the indicators will be o.
b. After the auto-ush is completed, turn on the
RO ltered water lever of the faucet to allow water
to run for 30 minutes to ush the air and carbon
nes through the lters. After that, the system is
ready and you can start to consume the ltered water.
Hot Cold
RO ltered
water
(1)
(2)
To Next Page
Loading...
Need help?
General
