11
VI. Maintenance
1. Routine maintenance
- Organic solvent such as gasoline etc. shall not be used for wiping the housing
of the device. If cleaning is required, please gently wipe the surface of the product
with a wet cloth after it is disconnected from the power supply.
- If the system is not used for more than 2 days, turn on the faucet and allow the
water to run for at least 5 minutes to flush the filters and the system.
- If the system will not be used for an extended period, take out the lter cartridges,
seal them with plastic wraps, and store them in the refrigerator (not in the freezer).
Turn off the three-way ball valve, turn on the faucet to empty the system, and
turn o the power. Before using it again, allow the water to run for at least 10 minutes
to flush the filters and the system.
2. Filter lifetime
Note
For the best performance, please change your filter cartridge according to the
filter lifetime indicator, or the filter replacement cycle suggested below. When a
signicantly lower ow rate is observed, we recommend changing the lters as well.
This system can only work with Philips filters.
System model code AUT2015
Filter, model code, and filter lifetime
CP filter, AUT706, 6-12 months*
RO filter, AUT747, 24-36 months*
d. Flush button
You may manually ush the system by pressing the ush button when the system
is in standby mode. During the flush, press the flush button again to stop it.
e. Reset button
To reset the lter lifetime, long press the reset button for 5 seconds. You will hear
a beep, and the indicator of CP filter lifetime flashes blue. Short press the reset
button again to select the filter that needs to be reset.
When the indicator of the selected lter ashes, long-press the reset button for
3 seconds. You will hear a beep, and the indicator will show constant blue light.
This means the filter lifetime has been reset successfully.
To Next Page
Loading...
Need help?
General
