Descaling
Aroma plus
Hot water
Espresso
Memo Memo
Calc
clean
Coffee
Milk clean
Memo
Cappuccino
When the CALC CLEAN button lights up continuously, you need to descale
the machine. If you do not descale the machine when this button indicates
this, the machine stops working properly. In that case, repairs are not
covered by the guarantee.
Only use the Saeco descaling solution to descale the machine.The Saeco
descaling solution is designed to ensure optimal performance of the
machine. The use of other products may damage the machine and leave
residues in the water. You can buy the Saeco descaling solution in the
online shop at www.shop.philips.com/service. The descaling procedure lasts
30minutes and consists of a descaling cycle and a rinsing cycle. You can
pause the descaling or rinsing cycle by pressing the ESPRESSO button. To
continue the descaling or rinsing cycle, press the ESPRESSO button.
Descaling procedure
1 Insert the hot water dispensing spout. (if it is not installed).
2 Remove and empty the drip tray and coffee grounds container. Place the
drip tray and coffee grounds container back into place.
3 Remove the water tank and the “INTENZA+” water filter from the water
tank (if present), replace it with the small white original one.
4 Pour the descaling solution in the water tank. Fill the water tank with
fresh water up to the CALC CLEAN level. Place the water tank back in the
machine.
5 Place a large container (1.5 l) under both the hot water/steam wand and
coffee dispensing spout.
Aroma plus
Hot water
Espresso
Memo Memo
Calc
clean
Coffee
Milk clean
Memo
Cappuccino
6 Press and hold the CALC CLEAN button for 3 seconds to start the
descaling cycle. The ESPRESSO button lights up continuously and the
CALC CLEAN button flashes throughout the cycle.
27
English
To Next Page
Loading...
Need help?
General
