Philips HTL4110B User Manual

7EN
2 Make sure the TV base is centered on it
and not hanging over any of its edges.
Tip
• If the TV base is too large to put on top of the
SoundStage, place the SoundStage in another location
such as on an open shelf under the TV, but keep it close
to your TV so the audio cable will reach. You can also
mount your TV on the wall above the SoundStage.
• If your TV comes with an anti-tip device, install it
according to the manufacturer's instructions and adjust
the tether after placing the TV on top the SoundStage.
• If placing the SoundStage in a cabinet or on a shelf, for
optimum audio performance, make sure the font of
the SoundStage as close as possible to the front edge
of the shelf.
• If placing the SoundStage backed up to a wall, make
sure there is at least a distance of 1 inch between the
wall and the rear of the SoundStage.
4 Connect and set
up
This section helps you connect your
SoundStage to a TV and other devices, and then
set it up.
For information about the basic connections of
your SoundStage and accessories, see the Quick
start guide.
Note
• Foridenticationandsupplyratings,seethetypeplate
at the back or bottom of the product.
• Before you make or change any connections, make sure
that all devices are disconnected from the power outlet.
Connect to TV
Connect your SoundStage to a TV to watch
videos. You can listen to the TV audio through
your SoundStage.
Use the best quality connection available on
your SoundStage and TV.
Connect to TV through HDMI (ARC)
Best quality audio
Your SoundStage supports HDMI with Audio
Return Channel (ARC). If your TV is HDMI ARC
compliant, you can hear the TV audio through
your SoundStage by using a single HDMI cable.
TV

Philips HTL4110B Specifications

General

Package depth	372 mm
Package width	800 mm
Package height	142 mm
Package weight	8600 g
Impedance	4 Ω
Number of tweeter drivers	1
Soundbar speaker RMS power	40 W
Tweeter diameter (imperial)	1 \
Total Harmonic Distortion (THD)	10 %
Quantity outer carton	1 pc(s)
Width (cm) outer carton	38.8 cm
Height (cm) outer carton	17.1 cm
Length (cm) outer carton	82 cm
Docking connector type	-
Apple docking compatibility	Not supported
Master (outer) case weight	9510 g
Audio decoders	Dolby Digital
RMS rated power	80 W
Audio output channels	2.1 channels
Audio Return Channel (ARC)	Yes
Product color	Black
Recommended usage	Universal
Audio formats supported	MP3, WMA
Consumer Electronics Control (CEC)	EasyLink
AC input voltage	110-240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	20 W
HDMI version	1.4
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired & Wireless

Weight and Dimensions

Depth	325 mm
Width	701 mm
Height	68 mm
Soundbar weight	6500 g