01_19
ENGINE CONTROL WARNING LIGHT AND ENGINE FAILURE WARNING LIGHT
The warning light signals possible failure detected by the engine control unit. After the
initial check of switching to «ON», the warning light, in case of failure, has two different
signal modes:
•
LIT CONSTANTLY
A failure was detected, which could compromise/degrade the engine performance.
•
FLASHING WARNING LIGHT
A failure was detected, which could compromise the rider's safety, therefore the en-
gine performance is deliberately degraded.
In both cases please contact an Authorised Service Centre.
01_20
Maintenance icons (01_20)
The maintenance icon flashes for five seconds each time the vehicle is turned on after
the check of the dashboard, since 300 km before the expiry of each service coupon.
Similarly, upon achieving the determined distance from the periodic maintenance in-
tervals (the first at 1000 km and then from 5000 km included, after every 5000 km),
the icon stays on until the established maintenance is performed.
For routine maintenance and icon reset, contact an Authorised Service Centre.
OTHERWISE MAKE THE FIRST CHECK, AS DEFINED AND DETERMINED BY
PERIODIC MAINTENANCE TABLE, AT A DISTANCE OF 1000 km.
21
To Next Page
Loading...
Need help?
General