Pioneer PD-50AE User Manual

16
> Before Start > Part Names > Install > Playback
Advanced Setup |Others
Advanced Settings
Advanced Setup
The unit allows you to configure advanced settings to
provide you with an even better experience.
1. Press SETUP on the remote controller.
2. Select the content or the setting with the cursors on the
remote controller and press ENTER to confirm your
selection. To return to the previous screen, press
RETURN.
3. To exit the settings, press SETUP.
AUTO STANDBY
This setting places the unit on standby automatically after
20 minutes of inactivity without any audio input.
"ON" (Default Value): The unit will automatically enter
standby mode.
"OFF": The unit will not automatically enter standby mode.
POWER ON PLAY
You can set it so that the disc automatically starts playing
when this unit is turned on.
• By using an externally connected auto timer, you can use
timer play when the power automatically switches on.
"ON": To play discs automatically
"OFF" (Default Value): When discs are not to be played
DIGITAL OUT
Make settings for digital audio output. When not connecting
to the DIGITAL OUT OPTICAL/COAXIAL jack, you can
listen to even clearer audio by setting this OFF.
"ON" (Default Value), "OFF"
DIGITAL FILTER
You can select the type of DIGITAL FILTER. (P15)
UP SAMPLING
Increasing the sampling frequency helps achieve sound
reproduction with a higher degree of clarity. (P15)
LOCK RANGE ADJUST
Adjust the lock range. (P15)
LOADING MODE
The loading time for CD can be shortened.
• Activating this function allows loading time to be
shortened depending on the CD, however, sound
skipping may occur at the beginning of playback.
"NORMAL" (Default Value): When the loading time for CD is
not shortened
"FAST": When the loading time for CD is shortened
1
AUTO STANDBY

Pioneer PD-50AE Specifications

Analog Audio Output

RCA OUT Rated Output Level	2.3 Vrms (1 kHz, 0 dB)
RCA OUT Impedance	100 Ω

Frequency and Noise

Frequency Response for CD	2 Hz - 20 kHz
Frequency Response for SACD	2 Hz - 50 kHz (-3 dB)
Signal to Noise Ratio for CD	116 dB or more (A-weighting)
Signal to Noise Ratio for SACD	116 dB or more (A-weighting)
THD+N for CD	0.002 % or less
THD+N for SACD	0.002 % or less

Digital Audio Output

Coaxial Digital Output Voltage	0.5 Vp-p
Coaxial Digital Output Impedance	75 Ω
Optical Digital Output Power	-14 - -21 dBm
Optical Digital Output Wavelength	660 nm

General

Power Supply	AC 220 - 230 V, 50/60 Hz
Power Consumption	43 W
Power Consumption in Standby	0.3 W
Dimensions	435 mm  138 mm  413 mm
Weight	13.1 kg