Pioneer VSX-521-K Service Manual

53
VSX-821-K
5
6 7 8
5
6 7 8
A
B
C
D
E
F
2. Notes on Ground Points Connection
During repair, before checking the MAIN Assy, etc., with the rear chassis removed, be sure to connect the
GND terminal of the main capacitor to the chassis back (speaker chassis), as shown below, then connect the
power cord.
Without grounding connection, the protection circuit will be activated.
After repairing, be sure to remove the ground wire before reassembling.
[Note]
Main capacitor GND
MAIN Assy (SIDE B)
Speaker chassis
Chassis back
GND wire
(Be sure to disconnect the GND wire
before reassembly.)

Pioneer VSX-521-K Specifications

General

Impedance	8 Ω
Receiver type	-
Frequency range	20 - 20000 Hz
RMS rated power	550 W
Audio output channels	5.1 channels
Signal-to-Noise Ratio (SNR)	79 dB
Total Harmonic Distortion (THD)	0.05 %
Power output per channel (1KHz@6 Ohm)	125 W
Power output per channel (20-20KHz@8 Ohm)	- W
AirPlay	No
Product color	Black
Audio decoders	Dolby Digital EX, Dolby Digital Plus, Dolby Pro Logic IIz, Dolby TrueHD, DTS-HD
Apple docking compatibility	Not supported
HDMI in	4
Digital audio coaxial in	1
Digital audio optical in	2
Multichannel audio input type	Terminals
Headphone connectivity	3.5 mm
Connectivity technology	Wired
AM band range	530 - 1700 kHz
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Preset stations quantity	30
AC input voltage	120 V
AC input frequency	60 Hz
Power consumption (standby)	0.4 W
Power consumption (typical)	415 W

Weight and Dimensions

Depth	363 mm
Width	435 mm
Height	168 mm
Weight	9000 g