3.61
ENGINE
3
Engine Break-In Period
The break-in period for a Polaris 4-Cycle engine is defined as
the first ten hours of operation, or the time it takes to use two full
tanks of gasoline. No single action on your part is as important
as a proper break-in period. Careful treatment of a new engine
will result in more efficient performance and longer life for the
engine. Perform the following procedures carefully:
1. Fill fuel tank with unleaded or leaded fuel which has a
minimum pump octane number of 87= (R+ M)/2.
2. Check oil level indicated on dipstick. Add oil if necessary
(Refer to Chapter 2, “Engine Oil Level” ).
3. Drive slowly at first to gradually bring engine up to
operating temperature.
4. Vary throttle positions. Do not operate at sustained idle or
sustained high speed.
5. Perform regular checks on fluid levels, controls and all
important bolt torques.
6. Pull only light loads during initial break-in.
7. Change oil and oil filter after break-in period at 25 hours.
CAUTION
Use only Polaris Premium 0-40W All Season
synthetic oil or equivalent.
Never substitute or mix oil brands.
Serious engine damage and voiding of
wa r r ant y c an re s ult.
Do not operate at full throttle or high speeds for
extended periods during the first three hours of
use. Excessive heat can build up and cause
damage to close fitted engine parts.
=
Capacity - Approximately 2 U.S. Quarts (1.9 l)
Oil Type - Polaris Premium 0W-40 Synthetic
Filter Wrench - PV-43527 or equivalent
- Oil Pressure Specification -
27-35 psi @ 6000 RPM, Polaris 0W-40
Synthetic, Engine at operating temperature.
To Next Page
Loading...
Need help?
General
