Polaris rzr 800 2008 User Manual

7.4
FINAL DRIVE
Bearing Installation
5. Thoroughly clean the front bearing carrier housing and the
outer race on the new bearing. Be sure that all oil residue
has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
7. Apply Loctite® RC™
680 to the outer circumference of
the new bearing race and carefully press the new bearing
into the bearing carrier housing.
NOTE: Use care to not allow any of the Loctite®
compound to get in the bearing.
8. Wipe the housing clean of any excess compound and install
the snap ring.
Bearing Carrier Installation
1. Install drive shaft axle through the backside of the bearing
carrier.
2. Install the upper and lower ball joint ends into the front
bearing carrier.
3. Install pinch bolts and torque to 17 ft. lbs. (23 Nm).
4. Apply grease to drive shaft axle splines.
5. Install front wheel hub assembly, cone washers, and hand
tighten the castle nut. Install washers with domed side out.
6. Install brake caliper mounting bolts and torque to 30 ft. lbs.
(40 Nm).
CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
Apply
Loctite® RC™
680
Bearing
Snap Ring
= T
Pinch Bolt Torque:
17 ft. lbs. (23 Nm)
17 ft. lbs.
23 (Nm)
Out
Cone Washers
Wheel
Hub
30 ft. lbs.
(40 Nm)

Polaris rzr 800 2008 Specifications

General

Brand	Polaris
Model	rzr 800 2008
Category	Utility Vehicle
Language	English