7.5
FINAL DRIVE
7
7. Install the steering tie rod end onto the front bearing carrier
and torque fastener to 42.5 ft. lbs. (58 Nm).
Torque wheel hub nut to 80 ft. lbs. (108 Nm) and install a NEW
cotter pin. Tighten nut slightly if necessary to align cotter pin
holes.
8. Install wheel and (4) wheel nuts. Torque wheel nuts to
specification.
9. Rotate wheel and check for smooth operation. Bend both
ends of cotter pin around end of spindle in different
directions.
= T
Front Caliper Mounting Bolt Torque:
30 ft. lbs. (40 Nm)
CAUTION
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
= T
Tie Rod End Fastener Torque:
42.5 ft. lbs. (58 Nm)
42.5 ft. lbs.
58 (Nm)
= T
Wheel Hub Castle Nut Torque:
80 ft. lbs. (108 Nm)
= T
Wheel Nut Torque:
Steel Wheels: 27 ft. lbs. (37 Nm)
Aluminum Wheels: 90 ft. lbs. (122 Nm)
80 ft. lbs.
NEW Cotter Pin
(108 Nm)
To Next Page
Loading...
Need help?
General
