50
OPERATION
Break-In Period
The break-in period for your new P olaris ATV is defined as the first ten
hours of operation, or the time it takes to use the first two full tanks of
gasoline. No single action on your part is as important as following
the procedures for a proper break-in. Careful treatment of a new
engine will result in more efficient perform ance and longer life for the
engine. Perform the following procedures carefully.
CAUTION
Excessive heat build-up during the first three hours of operation
will damage close-fitted engine parts. Do not operate at full
throttle or high speeds for extended periods during the first three
hours of use.
CAUTION
Mixing brands or using a non-recommended oil may cause
serious engine damage. We recommend the use of Polaris
Premium 4 synthetic Oil or another 0W-40 API certified SH oil.
Never substitute or mix oil brands.
1. Fill the fuel tanks with gasoline. See page 39.
2. Check the oil reservoir level on the dipstick. See page 75. Add
oil i f necessary to maintain the level between the safe and add
marks.
3. Drive slowly at first. Select an open area that allows room to
familiarize yourself with vehicle operation and handling.
4. Vary the throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 51.
6. Pull only light loads.
7. During the break-i n period, change both the oil and the filter at 20
hours, 200 miles, or one month, whichever comes first.
To Next Page
Loading...
Need help?
General
