88
MAINTENANCE
PVT System
The basic operation of the Polaris PVT system is dependent on engine
speed and vehicle torque requirements. As engine speed increases, the
force exerted on the movable drive sheave by the flyweights also
increases. This, in turn, increases the amount of “pinch” applied to the
drive belt. Similarly, if the engine speed decreases, t he amount of
centrifugal force decreases, reducing the amount of belt “pinch.” This
begins to occur at speeds of less than 5 MPH, due to the system’s
dependence on engine speed.
For example, when operating at a ground speed of 3 MPH, the engine
would be running at only about 1500 RPM, with an engagement speed
of about 1400 RPM. Whenever operating t his close to the engagement
point, the engine may be running at a speed too l ow to provide the
adequate “pinch” needed to prevent incomplete engagement.
Incomplete engagement creates excessive heat that can destroy belts
and clutch covers. In some cases, excessive clutch wear and damage
may result.
If the ATV will be operated for extended periods below 5 MPH, or for
towing loads, we recommend that you install a one tooth smaller
counter shaft s procket to raise the operating RPM far enough above the
engagement RPM to reduce heat caused by incomplete engagement.
Reducing t he temperature inside the clutch cover extends the life of the
PVT components (belt, cover, etc.).
NOTE: Avoi d h eavy p ulling and extended low-speed
operation.
To Next Page
Loading...
Need help?
General
