• Power Save Setting
Your camera is designed to turn off the LCD screen and the camera
automatically after a period of inactivity to save battery life. You can
change Power Save Setting by the following steps.
1. Turn the camera on.
2. Press Menu button and use the Right button to select “SETUP MENU”.
Press
Press
Press
Press
3. After the above operation, press Menu
button to exit.
The function for each setting is:
Off: This camera will not perform the power save function.
One minute: This camera will automatically turn off the LCD screen
after one minute of inactivity (the operation LED will
ash). Press any button will reactivate the LCD screen.
Three minutes: This camera will automatically turn off the LCD screen
after three minutes of inactivity (the operation LED will
ash). Press any button will reactivate the LCD screen.
After the above one minute/three minutes power saving, if there is no
more operation in another one minute, the camera will automatically
power off. You need to press the Power button if you want to turn on the
camera again.
NOTE:
• Power save setting is available in all camera modes.
• Auto power off is automatically disabled while the AC adaptor is connected
to the camera or the camera is connected to PC.
To Next Page
Loading...
Need help?
General
