• Taking Continuous Pictures
The camera will record pictures continuously 3 pictures when press
Shutter button.
1. Turn on the camera.
2. Set the Mode selector to Auto or Manual.
3. Press the Continuous Mode button to activate Continuous mode. The
icon
will appear on the LCD screen.
4. Press the Shutter button to take continuous pictures.
NOTE:
• The number of continuous pictures you can take will depend on the available
memory and the resolution settings.
• The ash does not re in the Continuous mode.
• Setting the Flash Mode
1. Turn on the camera.
2. Set the Mode selector to Auto or Manual.
3. Press the Flash button to cycle through the Flash Mode until the one
you want is shown on the LCD screen.
The camera has four ash modes. Different ash setting applied to
different situation:
Flash Mode on, the ash res for every picture. Use this setting in high
contrast situations to provide ll-light or use it indoors in low light.
Flash Mode off, the ash does not re. Use this setting for outdoor
pictures or where ash is prohibited or may be distracting. Also use
when shooting toward a reective surface, such as a window or
mirror. If you do not have enough light when using this setting, your
pictures will be too dark.
A
Auto Flash Mode, the ash res automatically as needed. Use this
setting to take most pictures.
Red eye, use this setting to avoid red glare in your subject’s eyes.
The camera res a brief, preash ash before the regular ash.
To Next Page
Loading...
Need help?
General
