8 INSTRUCTIONS PW220/PW230
2.3 Installation
2.3.1 Preparation for Motor Installation
PW220/PW230 is not applicable to a gate which is inefficient or unsafe, neither to solve the defects due to incorrect installation nor
poor maintenance.
Check the following items before going for installation:
1. Make sure the weight and dimensions of the gate conform to the operation range of PW220/PW230. Don’t
use PW220/PW230 if the gate specifications do not meet the requirements.
2. Make sure the gate structure conform to the criteria of automatic operation and force regulations.
3. Make sure there is no serious friction existing in the opening or closing travel of the gate leaves.
4. Make sure the gate is at horizontal level that the gate will not move aside at any position.
5. Make sure the gate can bear the impact of the motor torque when it is installed on any hole of the bracket which the surface
is sufficiently sturdy.
6. Make sure the photo sensors are installed on flat surfaces to ensure the two ends of receiving and transmitting corresponded
to each other.
7. Check the dimensions of the motors as below.
Figure 13
(1) Dimension of PW220 (2) Dimension of PW230
8. Make sure to leave enough space when the gate is opening.
Figure 14 (aerial view)
(1)PW220 (2)PW230
To Next Page
Loading...
Need help?
General
