2
PM-727MV v6 2020-10
Copyright © 2020 Quality Machine Tools, LLC
FAQ
This manual contains essential safety advice on the proper setup, operation, maintenance, and service
of the PM-727M and PM-727V mills. Failure to read, understand and follow the manual may result in
property damage or serious personal injury.
There are many alternative ways to install and use a milling machine. As the owner of the machine you
are solely responsible for its proper installation and safe use. Consider the material contained in this man-
ual to be advisory only. Quality Machine Tools, LLC cannot be held liable for injury or property damage
during installation or use, or from negligence, improper training, machine modications or misuse.
This manual describes PM-727 machines as shipped from January 2015. There may be detail
dierences between your specic machine and the information given here (with little or no impact
on functionality). Please email us if you have questions about any aspect of the manual or your
machine (see our website www.precisionmatthews.com for support addresses). Your feedback is
welcomed!
The collet locating screw could
be in too far. Back it out a little.
R8 collets won’t go
into the spindle
Copyright © 2020 Quality Machine Tools, LLC
This material was originated by Precision Matthews. No portion of
the manual may be reproduced or distributed in any form without
the written approval of Quality Machine Tools, LLC.
My mill doesn’t
run at all
110 Vac power connected?
Power lamp lit? (Press the
Power push-button lens)
E-Stop button in? (pop it out
by twisting rmly to the right.)
Fuse good?
PM-727M shown above.
The PM-727V panel, left,
is labeled dierently
(727V Forward = 727M
Left, Reverse = Right).
To Next Page
Loading...
Need help?
General
