5PM-727MV v6 2020-10 Copyright © 2020 Quality Machine Tools, LLC
Dimensions
Weight, including optional stand 575 lb net (475 lb without stand)
Size, assembled on stand W 40 in. x D 26-1/2 in. x H 70 in.
Stand footprint W 14-1/2 in. x D 21-1/4 in.
Tray W 23-1/4 in. x D 26-1/4 in.
Electrical
Power requirement 120V, 60 Hz, 1 phase
Spindle motor PM-727M Cap-start induction, 900W (1.2 HP), 1720 rpm
Spindle motor PM-727V Brushless dc, 1125W (1.5 HP), variable speed
Headstock
Vertical travel 16 in.
Left-right tilt 90° - 0° - 90°
Spindle
PM-727M Spindle speed, rpm 115, 220, 320, 600, 1120, 1700
PM-727V Spindle speed, rpm 40-190, 180-380, 350-560, 550-1000, 980-
1860, 1800-3000
Internal taper R8
Top end 6 splines, 22 mm OD
Quill travel 3 in.
Quill diameter 2-1/2 in.
Spindle nose to table 2-1/2” to 18-1/4 in.
Spindle centerline to front face of column 7-3/4 in.
Drawbar 7/16 - 20, 16 mm wrench
Table
Size W 27-1/2 in. x D 7-1/4 in.
Surface height over oor Approx 36 in.
Maximum load, centered 200 lb
Leadscrews Acme, inch pitch, 10 tpi
Left-right travel (X-axis) 15 in.
Front-back travel (Y-axis) 8-1/2 in.
T-slots (3) 12 mm wide, 63 mm centerlines
Model PM-727M and PM-727V specications
ABOUT THIS MANUAL ...
It was written before the PM-727V became available.
Unless otherwise noted, all descriptions, suggestions
and instructions apply equally to both PM-727M and
PM-727V machines. They are identical in all respects
other than the motor, single speed for the M model,
variable for the V.
To Next Page
Loading...
Need help?
General
