© 2012 by Proceq SA 19
6.4. Number of impacts per measurement series
In order to end a measurement series, the user can close the series using the function key
“Close”. Alternatively, if a fixed number of impacts, e.g. n = 5, is desired for each series,
automatic termination of the series after 5 recorded values can be set. To set a fixed
number of impacts, proceed as follows:
• Press the F4 key.
• Use the navigation keys to select the desired number of impacts.
• Confirm selection with the key.
i
Note: “Bad” measurement readings may be erased from a test series using
the navigation keys and then pressing the function key “Remove”. Make
sure readings are only removed in accordance with the relevant quality
guidelines, or restrict this function using user profile settings, respectively.
Note: Following closure of a test series, the user may decide to add fur-
ther readings or redo “bad” readings simply by pressing the function key
“More”. The function key “New” clears the display to start a new series.
To Next Page
Loading...
Need help?
General
