Pulsar Nova® sound level meter user manual
Page 35
Advanced Setup Options Using AnalyzerPlus
All the setup options available in the instrument menus and some more advanced setup
options can be set up from the AnalyzerPlus software.
Audio Note Enable/Disable
Audio Note can be enabled so that you can make an audio note before every
measurement or disabled from within AnalyzerPlus.
The default is: On.
Level Colours
The level in dB where the analog bar down the left hand side of the display changes from
green to yellow and from yellow to red can be changed within AnalyzerPlus.
The default is: Yellow at 80dB, Red at 85dB.
Time History Rate
The time history rate can be selected from, 2 seconds, 1 second,1/2 second (500ms),1/4
second (250ms), 1/8 second (125ms), 1/16 second (62.5ms), 1/100 second (10ms)
within AnalyzerPlus.
The default is: 1 second.
Audio Length
The maximum length of audio recorded can be set of 2 minutes, 5 minutes, 10 minutes
or unlimited within AnalyzerPlus.
The default is: unlimited length.
Ln’s Setup
The first seven Ln values are set by default to commonly used values (L1, L5, L10, L50,
L90, L95 and L99) and 8-14 are definable in AnalyzerPlus.
AC Output Settings
The AC Output can be enabled or disabled, have +20dB gain added to it, or have its
range set to High Levels (70-140dB) or Low Levels (20-90dB) within AnalyzerPlus.
The defaults are: Disabled, +20dB Gain Off and High Levels (70-140dB).
To Next Page
Loading...
Need help?
General
