Advanced Functions
Chime
The chime can be used for any input on the system.
This can be set up by your engineer.
To enable the chime on the keypad, when the time
is displayed, press c.
‘c’ will be displayed on the right side of the keypad
display. Press c again to clear the chime feature.
Alarm Panel
Time 10:09 c
Omitting Inputs
On occasion, a detector may need to be isolated if
a room is occupied.
Enter your User Code.
Press f.
Select the inputs that need to be omitted’
Press a.
After 10 seconds the exit time continues.
Omit Day Al [01]
Please note: Inputs have to be programmed as omittable by your engineer for this feature to operate.
Keypad Hold Up
A ‘hold up’ alarm will be generated when 1 and
7 are pressed and held down for 2 seconds (this
time period can be altered by your engineer).
Alarm Silenced
2 Key HU
Please note: The keyfob can also be programmed to initiate a hold up alarm. All hold up alarms including
duress codes must be enabled by the engineer.
To Next Page
Need help?
General
