QRS Pno
3
User Guide
QRS Music Technologies, Inc.
Technical Support - 800-247-6557
www.qrsmusic.com
QRS had developed a player violin. The
routing was to enable the violin to play in
sync on its own channel.
Turn on if you are controlling an external MIDI Player system, as
with our upgrade kits.
Turn on if your player responds to standard MIDI Controller 7
Volume messages. (most do)
Dierent systems respond dierently to volume changes. Under
setup master volume curves you can change
External Systems can sometimes have other instruments or
sounds connected on other channels. If you want controller 7
volume messages to control those as well as the pianos select
which channels.
Turn on if you have set a minimum velocity from key adjust you
would like to send to the system.
Number of notes in your player system, usually 80 or 88 or
somewhere in between. Run a test le up and down the
keyboard to determine.
Lowest MIDI note is the MIDI standard designation number for
that note. #21 is rst note on bass end of 88 note keyboard.
Open Overlay was a preset we created for Music Producers
working with DAW. It allows them to quickly switch between
operational modes, like record MIDI to DAW, then out of DAW
to MIDI in...
The QRS/Story & Clark Nickelodeon has 12 instruments and speaker
built in. When this is turned on it enables all the relevant channels to
work correctly
Routing and Delays - MIDI Options
Setup of General MIDI Options
To Next Page
Loading...
Need help?
General
