18
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Before you begin...
• Connect Camcorder to power source.
Use AC Adaptor for longer recordings.
• Insert cassette with record tab (page 10).
• Set POWER to CAMERA.
Camera Recording
1 Press MENU for MENU
mode. Press UP or
DOWN to select
PROGRAMMED REC .
2 Press DISPLAY.
(Current time is
displayed.)
Each additional press
of DISPLAY increases
start time by 30 minutes.
3 Press DOWN to select
REC TIME .
Press DISPLAY
repeatedly to select one
of the options shown at
left.
To cancel the setup, press MENU twice.
4 Press RECORD/PAUSE
to place Camcorder in
stand-by mode.
Recording will be done as scheduled.
Note:
• Start time may not be set over 24 hours from
current time.
• Camcorder shuts off at tape end, or 12 hours
after Interval Recording starts.
• To cancel, set
POWER to OFF.
Set a recording start and stop time. Or,
set a 5 or 10 second interval recording
to be done each minute.
*1 Record 5 seconds each minute.
*2 Record 10 seconds each minute.
REC TIME :
Programmed Recording
4
1, 2, 3
03.VM-D52 Basic p16-18 02.1.28, 9:56 AM18
To Next Page
Loading...
Need help?
General
