27
Special Features
1 Press D. ZOOM.
once ➞D.ZOOM 1 (150× maximum)
twice ➞D.ZOOM 2 (700x maximum)
The Higher digital magnification levels
may cause picture distortion.
2 Hold down “T” on POWER ZOOM.
Digital Zoom starts when normal zoom
reaches maximum (20×).
• Zoom level appears in EVF.
• POWER ZOOM switch controls digital
zoom level.
• Normal zoom resumes when level falls
to 20×.
3 Press D. ZOOM to turn off Digital Zoom
so no indication appears.
Digital Zoom
Power Zoom magnification is digitally
increased.
Before you begin...
• Connect Camcorder to power source.
• Set POWER to CAMERA.
2
1, 3
Digital Electronic Image Stabilization (E.I.S.)
1 Press EIS to display “EIS” in the EVF.
• Image becomes slightly enlarged and
shutter speed auto-adjusts from 1/80 to
1/350 according to brightness.
• Use High Speed Shutter (page 24) if
needed. Shutter speed setting remains
after EIS is canceled.
2 Press EIS again to cancel when not in
use.
E.I.S. may not function during...
• extreme Camcorder movement.
• recording of subjects with distinct horizontal
or vertical stripes.
• low light situations (EIS indicator flashes).
• intense fluorescent lighting situations.
• recording of very fast motion.
Helps stabilize picture when recording in
unstable situations.
Before you begin...
• Connect Camcorder to power source.
• Set POWER to CAMERA.
NORMAL
Digital EIS ON
1, 2
05.VM-D52 Special p22-28 02.1.28, 9:57 AM27
To Next Page
Loading...
Need help?
General
