Section III - Installation
12 Quincy Compressor-QSI
®
• Receiving
• Moving the Unit to the Installation Site
• Location
• Piping Connections
• Relief Valves
• Electrical
• Guards
• Manual Vent and Shuto Valves
• Water and Sewer Facilities at the Installation
Site (Water-cooled models only)
• Compressor Rotation
• Fan Rotation
Receiving
Upon receipt, immediately inspect the compressor for any
If visible damage is found, the delivering carrier should
make a notation on the freight bill and the customer
-
-
-
Read the compressor nameplate to be sure the compressor
is the model and size ordered and that optionally ordered
Check the reservoir and pressure relief valves to be sure
they are adequate for the pressure at which you intend to
Moving the Unit to the Installation Site
Forklift slots are provided in one side and one end of the
CAUTION!
Improper lifting may result in component, system
damage or personal injury. Follow good shop
practices and safety procedures when moving
the unit.
To Next Page
Loading...
Need help?
General
