Section IV - Operating Procedures
Starting the Compressor
•
• Open the service valve to the plant air distribution
• Select the mode of operation and start the compres-
• Watch for excessive vibration, unusual noises or air/
• Control settings have been adjusted at the factory;
however, they should be checked during start-up
-
Never increase air pressure settings beyond factory
•
hour of operation and frequently for the next seven
Stopping the Compressor
Normal Operation
Close the service valve to the plant air distribution sys-
NOTICE!
Close the service valve when the compressor is
not being used to prevent the system’s air pres-
sure from leaking back into the compressor if the
check valve leaks or fails.
Emergency
Press the emergency stop button or cut the power at the
Quincy Compressor-QSI
®
17
To Next Page
Loading...
Need help?
General
