Figure: Lining Up and Mating Inner and Outer Shells
(note: Cap is not shown above but is on the cable to the le of the inner shell)
(1) Inner shell with so plug in place (wide end ridge of so plug remains outside)
(2) Outer shell
(3) Metal-shielded RJ45 plug
The following photo shows how the inner and outer shells appear aer they are mated with each other.
Figure: Mated Inner and Outer Shells
E.8 Connect RJ45 to Female WAPV RJ45
Connect the RJ45 plug to the RJ45 port on the ES1-5050CS.
Figure: RJ45 Connection
(1) Female WAPV RJ45 port on ES1-5050CS enclosure (will be on the bottom when ES1-5050CS is
mounted)
(2) Male metal-shielded RJ45 plug (arrow pointing at the plastic latching tab)
(3) Combined male WAPV inner and outer shell w/ so plug and so circular washer
(4) Cap
Note the location of the RJ45 plug’s plastic latching tab, pointed at by arrow (2) in the photo above.
To Next Page
Loading...
Need help?
General
