Preparing for Use
R&S
®
RTC1000
12Getting Started 1335.7346.02 ─ 02
2. Connect the power cable to the socket outlet.
3. Switch the main power switch at the rear of the instrument to position I.
The ON/OFF key lights up when the instrument is in standby mode. The key is
located next to the upper right corner of the screen.
You can leave the main power switch on to preserve your last instrument settings.
To disconnect from power supply, power off the instrument.
3.3.2 Starting Up and Shutting Down
To start up the instrument
1. Make sure that the R&S RTC1000 is connected to the AC power supply and
the main power switch on the rear panel is in position I.
2. Press the ON/OFF key. The key is located next to the upper right corner of the
screen.
The instrument performs a system check and starts the firmware. If the previ-
ous session was terminated regularly, the oscilloscope uses the last settings.
Table 3-1: Colors of the ON/OFF key
Unlit Instrument is on: firmware is working
Red Standby: instrument is off, main power switch is on
Warm-up and prepare the instrument
Make sure that the instrument has been running and warming up before
you start the self-alignment and the measurements. The minimum warm-up
time is about 20 min.
To shut down the instrument to standby state
► Press the ON/OFF key.
All current settings are saved, and the software shuts down. Now it is safe to
power off the instrument.
Starting the Instrument
To Next Page
Loading...
Need help?
General
