For Your Safety
R&S
®
RTC1000
5Getting Started 1335.7346.02 ─ 02
1 For Your Safety
The R&S RTC1000 digital oscilloscope is designed for measurements on circuits
that are only indirectly connected to the mains or not connected at all. It is not
rated for any measurement category.
The instrument must be controlled by personnel familiar with the potential risks of
measuring electrical quantities. Applicable local or national safety regulations and
rules for the prevention of accidents must be observed.
Safety information is part of the product documentation. It warns you about the
potential dangers and gives instructions how to prevent personal injury or dam-
age caused by dangerous situations. Safety information is provided as follows:
●
The "Basic Safety Instructions" in different languages are delivered as a prin-
ted brochure with the instrument.
●
Throughout the documentation, safety instructions are provided when you
need to take care during setup or operation.
Risk of injury
The instrument must be used in an appropriate manner to prevent electric
shock, personal injury, fire, or damage:
●
Do not open the instrument casing.
●
Do not use the instrument if the instrument casing, the display or any
accessory are damaged. If you detect or suspect any damage, have the
instrument or accessory inspected by qualified service personnel.
●
Do not operate the instrument in wet, damp or explosive atmospheres.
Make sure that the instrument, cables and connectors are completely
dry before connecting the inputs.
●
Do not exceed the voltage limits given in Chapter 4.1.1, "Input Connec-
tors", on page 16.
To Next Page
Loading...
Need help?
General
