To Next Page

To Previous Page

Preparing for Use

R&S

RTC1000

14Getting Started 1335.7346.02 ─ 02

3.4 Replacing the Fuse

The instrument is protected by a fuse. You can find it on the rear panel between

the main power switch and AC power supply.

Type of fuse: Size 5x20 mm, 250V~, T2.5H (slow-blow), IEC60127-2/5

Risk of electric shock

The fuse is part of the main power supply. Therefore, handling the fuse

while power is on can lead to electric shock. Before opening the fuse

holder, make sure that the instrument is switched off and disconnected from

all power supplies.

Always use fuses supplied by Rohde & Schwarz as spare parts, or fuses of

the same type and rating.

1. Pull the fuse holder out of its slot on the rear panel.

2. Exchange the fuse.

3. Insert the fuse holder carefully back in its slot until it latches.

Replacing the Fuse

Other manuals for R&S RTC1000

Questions and Answers:

Need help?

Do you have a question about the R&S RTC1000 and is the answer not in the manual?

General