Caution:
M
+
e sure the camcorder’s power is turned off
when you attach or remove a power supply. Removing
the power supply during recording or playback may cause
damage to the
tape.
Using the
AfapterKharger
to Power Your
Camcorder I
AC Adapter/Charger
PO
WEd
Indicator
Power C+umecto2
-
\
BATTERY RELEASE Button
power connector attaches’ to the
power your camcorder directly from
Because the adapter/charger
operates on
lOOi
volts,
50160
Hz, it can be used virtually
anywhere in
the
world.
Note: A plug addpter may be required in some countries. Consult
traveling, as the adapter may be hard to find in
1.
Connect the wer connector’s small plug into the
on the adapter/charger.
the back of the
To Remove
then
Adapter/Charger
aptericharger
from the wall outlet.
RELEASE
button on the
ile sliding the power connector to the left
Using the Battery to Power Your Camcorder
The battery must be charged before it can be used the first
time. Initial charging will take approximately
1
-l/2
hours.
When fully charged, the battery should supply about 55
minutes of operating time (depending on how much you
use
zoom and pause).
Note: The small marker switch on the top
of the
battery is for
use
as a personal reminder to help you remember to recharge the battery.
It has no other function.
Charging the Battery
POWER
Reference
To AC
Outlet
CHARGE
Indicator
Caution:
When a battery is attached to the adapter/
charger, do not turn them upside down. The battery may
fall off and be damaged or cause injury.
If the power connector is attached to the adapter/charger,
remove its plug.
1. Align the reference marks on the battery with the mark on
the adapter/charger.
2.
Hotd
the battery flush against the adapter/charger and slide
it in the direction of the arrow.
3. Plug the adapter/charger into the nearest AC outlet
(
100-24OV.
50/6OHz).
4. If the battery is properly connected, the adapter/charger’s
CHARGE indicator will light. When the light turns green,
the battery is fully charged.
5. Remove the charged battery by sliding it off the
adapter/charger.
6. Attach the charged battery to the camcorder as
shown on
the next page.
6
I
(continued on next page)
To Next Page
Loading...
Need help?
General
