Flash Photography
Using Auto Flash
Your camera has three flash modes; ON, OFF, and
AUTO. If set to AUTO, the camera uses a sensor to
determine if enough light is available to take a good
picture, ff a sufficient light value is measured through
the CCD sensor, the built-in flash will not fire. If
additional light is required, the built-in flash will fire
automatically.
• To turn on the flash to AUTO, press the i (Flash)/-
(minus) button on top of the camera until the iAicon
is displayed on the LCD.
Flash ON Mode
Daylight flash photography is effective for backlit
subjects, when strong shadows are present, or on cloudy
days. In these conditions, flash photography allows more
natural-looking pictures to be taken by softening harsh
shadows. When the flash is used, an effective shutter
speed from 1/3 to 1/1000 of a second is used.
• Press the (FLASH)/- button on top of the camera
until the _ symbol is displayed on the back panel
LCD. When activated, the flash will fire with every
picture taken.
Hash OFF Mode
This mode forcibly prevents any fLring of the flash and
extends exposure time upto
1/3 of a second, thus allowing sufficient exposure in
museums, churches, or anywhere flash photography is
prohibited.
• Press the (FLASH)/- button on top of the camera
until the FLASH OFF icon ((_)) is displayed on the
back panel LCD to turn the flash off. When turned
off, the flash will not fire no matter what the lighting
conditions are.
22
To Next Page
Loading...
Need help?
General
