58 Chapter 4
Using the TV’s Menu System
SVM
SVM stands for Scan Velocity Modulation. This feature improves the sharpness of
the picture by changing the speed of the cathode-ray tubes’ electron beam when
it transitions between dark and light areas of the screen. It sharpens the black-to-
white edges and white-to-black edges. Choose On or Off, depending on your
preference.
Reset Controls
The Reset Controls menu button resets all picture quality controls to their
original factory settings (except for the convergence settings) for the current
input.
1. Tune to the “input” for which you would like to apply the setting.
2. Press MENU to access the main menu.
3. Select Picture Quality, and then select Reset Controls to set reset the settings
for the currently tuned input.
Graphic Equalizer
The seven-band graphic equalizer lets you adjust the audio frequency settings.
The equalizer can only be changed if the Fixed/Variable Audio Output is set to
Variable Output. If the Fixed/Variable Audio Output is set to Fixed Output, you
cannot make changes to the equalizer and the bands are set to 0dB. However,
the graphic equalizer levels for Variable Output are stored in memory in case
you switch to Fixed Output then back to Variable Output.
Note: If the internal speakers are used as the center channel audio
speaker from an external audio receiver, the graphic equalizer settings do
not apply.
Audio Menu
The Audio menu lets you adjust audio output. To access the Audio menu, press
MENU on the remote, and then select Audio from the main menu. The
following audio items can be adjusted: Graphic Equalizer, Audio Processor,
Sound Logic, Audio Language, SAP, Balance, Fixed/Variable Out, Digital Audio
Out, Subwoofer.
To Next Page
Loading...
Need help?
General
