References
76 Chapter 5
Accessory Information
The following accessories are available from most dealers and electronics supply stores in case
you want to position your components farther apart or need additional cables.
Monaural VCR Dubbing
Audio/Video Cable is a
double cable that lets you
connect the video and audio
jacks of two VHS VCRs to
duplicate tapes. It can also be
used to connect a VCR to your
TV. The cable is color-coded
and shielded. It has RCA-type
phono plugs on each end.
Gold-Tipped cable, VH83 (6-ft)
Stereo VCR Dubbing Audio/
Video Cable is a triple cable
that lets you connect the
VIDEO
and AUDIO jacks of stereo
components. Gold-Tipped
cable, VH84 (6-ft)
Push-on Cable* attaches to
the round antenna connectors
(called 75-ohm F-type) on the
back of your VCR or TV. The
ends push on for a quick
connection. VH89 (6-ft)
Screw-on Cable* attaches to
the round antenna connectors
(called 75-ohm F-type) on the
back of your VCR or TV. The ends
screw onto the connectors for a
secure connection. VH82 (6-ft),
VH81 (3-ft)
S-Video Cable has multi-pin
connectors on each end for
connecting S-Video components
to your TV. VH976 (6-ft), VH913
(12-ft)
RG-6 Coaxial Burial
Cable with weatherproof “F”
connectors. D905
Optical/SPDIF cables help you
connect to a component with an
Optical Audio In jack, such as a
Dolby Digital decoder or
receiver. DV3 (3-ft), DV6 (6-ft)
* This accessory is intended for use with an off-air or cable TV signal distribution and is not suitable for distribution of the
satellite signal originating from your satellite dish antenna.
To Next Page
Loading...
Need help?
General
