5. On the base (25413/25414/25415), press and hold the PAGE
button for 2 seconds. If the registration is successful, the
handset will emit a long beep sound.
6. If the registration fails, "
FAIL! TRY AGAIN
" will show on the
display. Please repeat the above steps.
BASIC OPERATION
ANSWERING A CALL
Check the display to see who is calling.
1. Press the TALK button on the handset. The message
“Cordless H/S in-use” on the base comes on whenever the
handset is on.
2. When finished, press TALK to hang up.
MAKING A CALL
1. Press the TALK button to access an available line automatically,
OR
If you want to select a desired line, press LINE button plus a
number button (1-4) to select the desired line.
2. Wait for a dial tone then dial the desired number.
3. When finished, press TALK to hang up.
NOTE: If the line you selected is occupied by other users, the
message "LINE IN USE" will be shown. You can press the OK button
to confirm selection of this line. If you wants to select another line,
press the LINE button plus the number button again.
MANUAL CHANNEL SELECTION
While talking, you might need to manually change the channel
in order to reduce static caused by baby monitors, garage door
openers, or other cordless phones. Press and release the
Channel/Delete button on the cordless handset to advance to the
next clear channel.
CALL TIMER
After you press TALK or LINE plus number button to seize the
line on the cordless handset, the built-in call timer shows in the
display and begins counting the length of time of the call.
AUTO STANDBY
Placing the cordless handset in the charge cradle while the
handset is off the hook (or during a call) automatically hangs up
the handset.
RINGER ON/OFF SWITCH
Use the two-position switch on the cordless handset to turn the
ringer volume off or on.
To Next Page
Loading...
Need help?
General
