IMPORTANT INSTALLATION INFORMATION
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
• Never touch non-insulated telephone wires or terminals,
unless the telephone line has been disconnected at the
network interface.
• Use caution when installing or modifying telephone lines.
•Temporarily disconnect any equipment connected to the
phone such as faxes, other phones, or modems.
IMPORTANT INSTALLATION GUIDELINES
•Install telephone near both a telephone (modular) jack and an
electrical power outlet.
•Avoid sources of noise, such as a window by a busy street,
and electrical noise, such as motors, microwave ovens, and
fluorescent lighting.
•Avoid heat sources, such as heating air ducts, heating
appliances, radiators, and direct sunlight.
•Avoid areas of excessive moisture or extremely low temperature.
•Avoid dusty locations.
•Avoid other cordless telephones or personal computers.
INSTALLING THE PHONE
Choose the best location to install handset charge cradle. Your
handset charge cradle should be placed on a level surface such
as a desk or table top.
CONNECTING THE AC (ELECTRICAL) POWER
1. Plug the power supply cord into the power jack on the back
of the charge cradle and the other into an electrical outlet.
CAUTION: Use only the ATLINKS USA, Inc. 5-xxxx (black) and
5-xxxx (white) power supply that came with this unit. Using
other power supplies may damage the unit.
To Next Page
Loading...
Need help?
General
