Starting setup
The Starting Setup menu appears the first time
you turn on the TV, and assists you to select the
menu language, specify the Air/Cable setting,
and program your channels automatically.
IMPORTANT: Make sure that the antenna or cable
TV system connection is made!
1 To turn on the TV, press POWER (POWER
indicator on the front of the unit changes green.
It may take approx. 10 seconds for a picture to
appear on screen.). The starting setup function
begins. Press < or • to select your desired
language.
2
3
4
Press • or • to select "Signal Type", then press
< or • to select "Cable" or "Air".
Press • or • to select "Automatic Search", then
press • or ENTER.
Now the "Auto Setup" starts. After the starting
setup is completed, the TV channel appears on
the screen.
• Depending on the reception condition, it may
take from 15 minutes to 30 minutes to complete
memorizing digital cable channels. Please be
patient.
NOTE:
• If you press EXIT/CANCEL in the process of "Auto
Setup", the Starting Setup stops and changes to the
normal screen.
• When you make a menu selection, your changes
occur immediately.You do not have to press EXIT/
CANCEL to see your changes.
• When you are finished programming the menus,
press EXIT/CANCEL
Setting the on-screen
language
You can choose from three different languages
(English, French and Spanish) for the on-screen
displays.
Select the language you prefer first, then
proceed with the other menu options.
1 Press POWER.
2 Press TV/DVD to select TV mode.
3 Press SETUP/TV MENU.TheTV menu screen
will appear.
4 Press • or • to select"Setup", then press • or
ENTER.
5 Press • or • to select"Language".
6
7
Press < or • to select the desired language:
English, French (Frangais) or Spanish (Espa_ol).
Press EXIT/CANCEL to return to the normal
screen.
NOTE:
• If no buttons are pressed for more than about 60
seconds, the menu screen will return to normal
operation automatically.
Memorizing channels
This TV is equipped with a channel memory
feature which allows channels to skip up or down
to the next channel set into memory, skipping
over unwanted channels. Before selecting
channels, they must be programmed into the
TV's memory.To use this TV with an antenna, set
the Signal Type option to the Air mode. When
shipped from the factory, this menu option is in
the Cable mode.
Air/Cable selection
1 Press SETUP/TV MENU in the TV mode.The TV
menu screen will appear.
2 Press • or • to select "Channel", then press •
or ENTER.
3 Press • or • to select"Auto Ch Memory", then
press • or ENTER.
4 Press • or • to select"Signal Type".
5 Press < or • to select"Air" or"Cable".
O Press EXIT/CANCEL to return to the normal
screen.
15
To Next Page
Loading...
Need help?
General
