IMPORTANT SAFETY INSTRUCTIONS
1
2
3
4
5
6
7
8
Read these instructions.
Keep these instructions.
Heed aHwarnings.
Follow all instructions.
Do not use this apparatus near water.
CNean onHywith dry cloth.
Do not Mock any ventimafion openings. RnstaHin accordance with the manufacturer's instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9 Do not defeat the safety purpose of the poRarized or grounding-type pHug.A poHarized pHughas two
blades with one wider than the other. A grounding type pRughas two bmadesand a third grounding
prong. The wide blade or the third prong are provided for your safety. If the provided plug does not
fit into your outlet, consuHt an emectrician for replacement of the obsomete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacmes, and the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for mongperiods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or
obiects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
15) Apparatus should not be exposed to dripping or splashing, and objects filled with liquids, such
as vases, should not be placed on the apparatus.
16) An outside antenna system should not be located in the vicinity of overhead power lines or
other electric light or power circuits, or where it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care should be taken to keep from touching such
power lines or circuits, as contact with them might be fatal.
17) Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric
shock.
18) Do not push objects through any openings in this unit, as they may touch dangerous voltage
points or short out parts that could result in fire or electric shock. Never spill or spray any type of
liquid into the unit. EXAMPLEOFANTEN,AGROU,D_NGASPERTHE
NATIONAL ELECTRICAL CODE
19) If an outside antenna or cable system is --__
connected to the unit, be sure the antenna or
cable system is grounded to provide some /.
protection against voltage surges and built-up
static charges, Section 810 of the National
Electrical Code, ANSl/NFPA 70, provides
information with respect to proper grounding of
the mast and supporting structure, grounding _UIPMENT_-_,_[
of the lead-in wire to an antenna discharge NEC-NATION__ POWERSERVlCEGROUNDING
unit, size of grounding conductors, location ELECTRICALCODE ELECTRODESYSTEIvl
of antenna discharge unit, connection to $2898A (NECART250.PARTH)
grounding electrodes, and requirements for the grounding electrode.
20) When replacement parts are required, be sure the service technician uses replacement parts
specified by the manufacturer or those that have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock or other hazards.
21 ) Upon completion of any service or repairs to this unit, ask the service technician to perform
safety checks to determine that the unit is in proper operating condition.
22) Keep your fingers clear of the disc slot as it is closing. It may cause injury.
To Next Page
Loading...
Need help?
General
