Unpacking the system
You should have the following:
•one main unit (with 2 main speakers);
• one remote control;
• one user’s guide;
• one safety leaflet;
• Owner registration card
Back View
1. FM Pigtail Antenna
2. Main Speaker Jacks
Using the Antenna
Before you use your audio system, you’ll want to
make sure the FM antenna is positioned properly.
The FM antenna is the coiled wire connected to
the back of the unit. Uncoil it, making sure it is
fully extended (you may even want to tape it to
the wall behind the unit, if possible. The higher,
the better.)
For better AM reception, move or rotate the unit.
Connecting the Speakers
RS2035 - Match the blue wire (on the left
speaker) to blue terminal for the left speaker (L)
on the back of the unit and the black wire (on
the left speaker ) to the black terminal for left
speaker (L). Follow the same procedure to
connect the right (R) speaker.
RS2035RD - Match the red wire (on the left
speaker) to red terminal for the left speaker (L)
on the back of the unit and the black wire (on
the left speaker ) to the black terminal for left
speaker (L). Follow the same procedure to
connect the right (R) speaker.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
2
EN
Getting Started
the terminal.
points.
down to insert wire.
To Next Page
Loading...
Need help?
General
