15
EN
Radio
Selecting Tuner Band
1. Press SOURCE to select TUNER. The TUNER
indicator lights.
2. Press BAND to select between AM or FM radio
band.
Tip: Your audio system has 32 preset stations.
Tuning to a Station
Press DIGITAL TUNING or on the main
unit or TUNE REW /TUNE F FWD on the
remote control to select frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE/PRESET on the main unit to toggle
TUNE and PRESET mode.
• Press DIGITAL TUNING or on the main
system or PRESET PREV or PRESET NEXT
on the remote control to access the previous or
next preset station. The display first shows the
preset program number and after a few seconds,
the frequency will be displayed. (FMPR:01 is FM
preset 1)
Auto Preset Programming (for FM only)
Press and hold BAND/AUTO PROG. button for 2 sec-
onds to scan stations in FM band. The stations will
then be stored as preset channels. A maximum 32 sta-
tions can be stored. Beware of your preset channels
being erased accidentally because the scanning and
storing process is automatic upon pressing and hold-
ing the button. You can stop the automatic scan by
pressing any button, but the erased stations cannot be
recovered.
Manually Setting Presets
1. Press TUNE/PRESET button to enter TUNE mode.
2. Press DIGITAL TUNING or to access
the desired frequency.
3. Press the PROG•SET button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
DIGITAL TUNING or to move to the
desired preset number (1-32).
6. Press PROG•SET to store the selected frequency at
that preset.
Suppressing Stereo Signal
Press CD INFO/ FM ST on the remote control to
toggle between FM mono and stereo for stereo FM
stations.
To Next Page
Loading...
Need help?
General
