39
References
Trouble Checks
Trouble Here's what to try:
Streaks in picture during normal playback
Will not record
Rewind does not operate
VCR Plus+ or timer recording not made
or wrong program recorded
Clock shows incorrect time or date
VCR makes noise when stopped
Will not auto-search channels active
channels correctly
Cannot add or remove channels
Cannot select channels over 69
Cassette with safety tab removed does not start to
play automatically
Segment of tape plays over and over
Stereo or SAP sound not recorded
No stereo sound during playback
Stereo audio too noisy
• Some snow/streaks are normal during search, frame advance, slow-motion,
or stop-action playback.
• VCR is in pause mode. Press PAUSE.
• Safety tab removed from cassette.
• Make sure the line indicator (LINE) is turned off in VCR’s display panel for
normal recording from the VCR’s tuner. Press INPUT to turn off the line
indicator.
• Tape already rewound.
• Wrong PlusCode entered.
• Cable box or satellite receiver was not turned on at time recording was to
begin.
• Program entered incorrectly (wrong channel or times).
• Power interruption. Clock area in display panel will show - -:- -.
• Check to see if time and date are correct — including AM/PM.
• Program exceeded tape’s length or tape was not rewound beforehand.
• VCR was not turned off at the time recording was to start.
• No tape in VCR or cassette’s safety tab broken off.
• Power interruption. Clock on the front panel will show --:--.
• Clock was not set accurately (check AM/PM and date).
• Time counter display appears in VCR’s display panel. Press DISPLAY on
remote.
• VCR is removing tape from heads. This is normal. The head cylinder inside
the VCR will continue to rotate for a few minutes after you put the VCR in
the stop mode.
• Check antenna connections.
• Check Signal Type: CABLE/ANTENNA feature. See page 8.
• Channels must be placed in memory using Auto-Search Channels feature
before channels can be added or removed from channel memory. See page 8.
• Cable channels over 69 can only be selected if Signal Type:
CABLE/ANTENNA feature is set to CABLE. Details are on page 8.
• Set Auto Play ON/OFF feature to ON. Details are on page 18.
• Auto Repeat feature turned on.
• Reception: STEREO/SAP/MONO feature must be set to STEREO to record
broadcast stereo. See page 32.
• Reception: STEREO/SAP/MONO feature must be set to SAP to record SAP.
See page 32.
• STEREO or SAP indicator not on. Station not broadcasting stereo or SAP.
• Tape Playback: HI-FI/LINEAR/MIX feature must be set to HI-FI to hear stereo
sound during playback. See page 17.
• Stereo signal is weak. Set Reception: STEREO/SAP/MONO feature to
MONO.
• Press one of the TRACKING up or down buttons to minimize the noise.
To Next Page
Loading...
Need help?
General
