16
NOTE: In optimal conditions, Jet can achieve a fast charge (80% of battery) connected to your Mac or PC within one
hour. Meanwhile, your Jet will be fully charged after a recommended four hour period.
WARNING: Using a different Micro-USB cord, other than the original cable provided, may shorten the battery life,
and in some cases damage the Jet permanently.
WARNING: Do not charge your device with Jet’s components unassembled. This will damage your Jet permanently.
WARNING: Do not overheat your device; this may cause thermal runway or explosion in some cases.
WARNING: Do not charge your device in low or high temperatures (i.e. below 0°C or above 40°C).
WARNING: After charging your device, enclose the USB protection cap tightly to prevent water entering Jet.
WARNING: If the battery seems damaged or inflated, stop using it.
USING AC WALL CHARGER
Alternatively, you can use an AC wall charger with an output of 1A and 5V.
FIRMWARE UPDATES
Recon Uplink automatically updates your Jet to the latest available software version each time you connect it to
your Mac of PC. Recon Uplink notifies you if there is any new updates available for your device.
SUPPORT
For service and support, tutorials, and FAQs, please visit: https://reconinstruments.desk.com or email
support@reconinstruments.com.
WARRANTY
Find the terms and conditions of Jet’s warranty, here:
http://reconinstruments.desk.com/customer/portal/articles/1136318--recon-warranty-services
BATTERY DISPOSAL INFPRMATION
Visit the following link below for Jet battery disposal information:
https://reconinstruments.desk.com/customer/portal/articles/843025
Jet is powered by a lithium-ion battery. If you are done using the device, it should be taken to a
recycle center for proper and safe disposal.
To Next Page
Loading...
General