THIS FURNACE IS NOT
APPROVED OR RECOMMENDED
FOR INSTALLATION ON ITS BACK,
WITH ACCESS DOORS FACING
UPWARDS, OR WITH SUPPLY AIR
DISCHARGING TO THE RIGHT
HAND SIDE WHEN FACING THE
FRONT OF THE FURNACE.
SEE FIGURES 6 AND 7 FOR PROP-
ER INSTALLATION OF HORIZON-
TAL MODELS.
SOME MODELS HAVE A SHIPPING
BRACKET INSTALLED TO PRO-
TECT THE BLOWER ASSEMBLY
DURING SHIPPING.
LOCATE AND REMOVE THE SHIP-
PING BRACKET FROM THE SIDE
OF THE BLOWER HOUSING
BEFORE OPERATING UNIT. SEE
FIGURE 7.
TH
E FOLLOWING MODELS INCLUDE
THE ADDITIONAL BRACKET (WHICH
MUST BE REMOVED) ON THE
BLOWER ASSEMBLY:
RGFE/RGGE/RGJF-09EZCMS
RGFE/RGGE/RGJF-10EZCMS
RGFE/RGGE/RGJF-12ERCMS
CLEARANCE -
ACCESSIBILITY
The design of forced air furnaces with
models as listed in the tables under
Figures 9 and 10 are certified by CSA
Laboratories for the clearances to com-
bustible materials shown in inches.
See name/rating plate and clearance
label for specific model number and
clearance information.
Service clearance of at least 24 inches
is recommended in front of
all furnaces.
FOR PURPOSES OF SERVICING
THIS APPLIANCE, ACCESSIBILITY
CLEARANCES, WHERE GREATER,
SHOULD TAKE PRECEDENCE OVER
FIRE PROTECTION CLEARANCES.
!
WARNING
FURNACES MUST NOT BE
INSTALLED DIRECTLY ON CARPET,
TILE OR OTHER COMBUSTIBLE
MATERIAL. INSTALLATION ON A
COMBUSTIBLE MATERIAL OTHER
THAN WOOD FLOORING MAY
RESULT IN FIRE CAUSING DAM-
AGE, PERSONAL INJURY OR
DEATH.
-GGE FURNACES MAY NOT
BE
INSTALLED DIRECTLY TO A COM-
BUSTIBLE FLOOR. A SPECIAL
FLOOR BASE IS REQUIRED.
-GFE upflow furnaces and -GGE
downflow furnaces are designed
and certified for installation on
combustible (wood only) floors.
-GGE downflow furnaces may be
installed on a cased evaporator coil
mounted on a combustible (wood
only) floor or (for installations with-
out an evaporator coil) installed on
a special base for combustible
floors mounted to a combustible
(wood only) floor. The nece
ssary
floor base for installing a -GGE fur-
nace in the downflow configuration
to a combustible (wood only) floor
is an accessory sold through fin-
ished goods. Following is a list of
floor base models by furnace input
size (see Figure 8).
RGGE
Furnace Special Base For
BTU’s Combustible Floors
60, 75 RXGC-B17
90, 105 RXGC-B21
120 RXGC-B24
Upflow furnaces are shipped with
a bottom closure panel installed.
When bottom return air is used,
remove the panel by removing the
two screws attaching the panel to
the front base angle. See filter sec-
tion for details (see Figure 12).
FIGURE 7
REMOVING SHIPPING BRACKET
92-24379-01
CAUTION
!
CAUTION
!
FIGURE 6
DOWNFLOW/HORIZONTAL FURNACE INSTALLED IN HORIZONTAL POSITION W/SUPPORT
BRACKETS
GAS
PIPE
INTAKE
VENT
ELECTRICAL
CONDUIT
RETURN
AIR
SUPPLY
AIR
EXHAUST
VENT
TRAP
A086801
10
To Next Page
Loading...
Need help?
General
