Troubleshooting
98
5
D
DD
D
Load paper by repeating steps
B
BB
B
and
C
CC
C
.
Note
❒ The tray can hold up to 4,000
sheets.
E
EE
E
Close the top cover of the large ca-
pacity tray (LCT).
Loading Paper in the
Interposer
Important
❒ Load paper on the side already
printed (the side you want as
front).
❒ Load paper in the interposer in the
same orientation as paper in the
paper tray.
❒ The staple or punching location
will be on the left side of the paper,
when you are facing the machine.
❒ Do not place anything on top of or
leave documents on the sensor.
This may lead to the paper size not
being correctly scanned or paper
jams.
❒ When using the Z-fold function,
the paper in the interposer must be
of the same size as the prints after
they have been Z-folded. If the pa-
per in the interposer is larger than
the Z-folded sheets, a misfeed
might occur.
A
AA
A
Load the paper.
B
BB
B
Adjust the paper guides to the pa-
per size.
ZGVY602E
ZGVY611E
MartiniC2_GBzen_F_pre_FM.book Page 98 Thursday, October 21, 2004 5:07 PM
To Next Page
Loading...
Need help?
General
