Loading Paper into Trays 2 and 3
In the following example procedure, paper is loaded into tray 2.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Check the paper edges are aligned at the right side.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease, the paper may
misfeed, or if it weighs between 52–59 g/m
2
(14–15 lb. Bond), it may wrinkle.
1. Carefully pull out the paper tray until it stops.
2. Square the paper and load it print side down.
Do not stack paper over the limit mark.
3. Carefully push the paper tray fully in.
• Various sizes of paper can be loaded in trays 2–3 by adjusting the positions of side fences and
end fence. For details, see "Changing the Paper Size in Paper Trays", Paper Specifications and
Adding Paper.
9. Adding Paper and Toner
124
To Next Page
Loading...
Need help?
General
