Messages Causes Solutions
"Cannot write on the
memory storage device
because the device is write-
protected."
The memory storage device
is write-protected.
Unlock the write-protection on the
memory storage device.
"Cannot write on the
memory storage device.
Check the memory storage
device and machine
settings."
The memory storage device
is faulty, or the file name
contains a character that
cannot be used.
• Check to see if the memory
storage device is defective.
• Check the memory storage
device. It might be unformatted,
or its format might be
incompatible with this machine.
• Check the file name set at the time
of scanning. For details about the
characters that can be used in file
names, see "Specifying the File
Name", Scan.
"Exceeded max. page
capacity per file. Press
[Write] to write the scanned
data to the memory storage
device, or press [Cancel] to
delete."
The scan could not be
completed because the
maximum number of pages
that can be scanned by this
machine was exceeded
during writing to the memory
storage device.
Reduce the number of documents to be
written to the memory storage device,
and then try again.
"Memory is full. Press [Write]
to write the current scanned
data to the memory storage
device, or press [Cancel] to
delete."
The scan could not be
completed because there
was insufficient hard disk
memory at the time of saving
to the memory storage
device.
Select whether or not to save the
scanned document to the memory
storage device.
Messages Displayed on the Client Computer
This section describes likely causes of and possible solutions for the main error messages displayed on
the client computer when using the TWAIN driver. If a message not described here appears, act
according to the message.
10. Troubleshooting
218
To Next Page
Loading...
Need help?
General
