English
31
English
Basic Operations
Powering Off the Projector
1. Press the Power button and you will see a message as below
on the on-screen display.
Power Off?
Press power key again.
2. Press the Power button to turn off the projector lamp.
3. The cooling fan continues to operate for about 30 seconds
(XGA and WXGA) or 120 seconds (WUXGA) for cooling
cycle and the Power indicator will ash red. After cooling
down, the light stops ashing, and then the projector will
enter the standby mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press
the Power button to restart the projector.
4. Disconnect the power cord from the electrical outlet and the
projector.
To Next Page
Need help?
General
