64
English
LAN Control
Control
You can control the projector with this item.
The items for control are described in this section.
Control button: When you click a button, the corresponding function
will be performed.
Power On The power of the projector turns on.
To turn ON, click "Settings" → "Network
(standby)".
Power Off Turns OFF the power of the projector.
Auto Set The RGB signal from the computer is
automatically adjusted.
Input The input signal of the projector changes to
the next signal.
Function button: When you click a button, the corresponding function
will turn ON/OFF. (Function of the time of ON is described here.)
Auto Source You will be automatically switched to the next
input when the input signal is lost.
AV Mute The video and audio will turn off temporarily.
Freeze The images will freeze.
3D Mode Images that support 3D display will be projected.
L/R Reverse Left/right video of DLP Link 3D glasses is
switched.
The projector name
set here is also used in
PJLink control.
Only alphanumeric
characters and symbols
can be used as projector
name. The maximum
number of characters is
22.
You can use
only alphanumeric
characters and symbols
in the password. The
maximum number
of characters is 8. If
you enter an invalid
character, “Invalid
Character” warning is
displayed.
If the characters of
new password and the
characters of conrm
(new) password do not
match, error message
will be displayed. In
this case, re-enter the
password.
N
o
t
e
To Next Page
Loading...
Need help?
General
