English
23
English
Installation
Powering Off the Projector
1. Press the “Power” to turn off the projector lamp, you will
see a message as below on the on-screen display.
2. Press the “Power” again to conrm.
3. The cooling fan continues to operate for about 60 seconds for
cooling cycle and the Power indicator will ash red. When
the light stop ashing, the projector has entered standby
mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press
“Power” to restart the projector.
4. Disconnect the power cord from the electrical outlet and the
projector.
To Next Page
Loading...
Need help?
General
