If you are scanning multiple originals, place them on the machine, and then press the [Start]
key.
Repeat this step until all originals are scanned, and then press the [ ] key.
• When scanning from the ADF
Transmission starts immediately after originals are scanned.
Using Scan to Folder in the Windows Environment
The following procedures explain how to create a shared folder on a computer running Windows, and
how to confirm the computer's information. In these examples, Windows 7 Ultimate is the operating
system, and the computer is a member in a network domain. Write down the confirmed information.
Step 1: Confirming the user name and computer name
Confirm the user name and the name of the computer you will send scanned documents to.
1. On the [Start] menu, point to [All Programs], then [Accessories], and then click on
[Command Prompt]
2. Enter the command "ipconfig/all", and then press the [Enter] key
3. Confirm the name of the computer
The computer's name is displayed under [Host Name].
You can also confirm the IPv4 address. The address displayed under [IPv4 Address] is the IPv4
address of the computer.
4. Next, enter the command "set user", and then press the [Enter] key (Be sure to put a
space between "set" and "user")
5. Confirm the user name
The user name is displayed under [USERNAME].
Step 2: Creating a shared folder on a computer running Microsoft Windows
Create a shared destination folder in Windows and enable sharing. In the following procedure, a
computer which is running under Windows 7 Ultimate and participating in a domain is used as an
example.
• You must log in as an Administrators group member to create a shared folder.
• If "Everyone" is left selected in step 6, the created shared folder will be accessible by all users. This
is a security risk, so we recommend that you give access rights only to specific users. Use the
following procedure to remove "Everyone" and specify user access rights.
6. Scan
64
To Next Page
Loading...
Need help?
General
Weight and Dimensions
